FMS.exe Error/Closes

[rckowal]

My FMS 2 Alpha 85 has stopped working. It's been a few months since I last used it - it ran OK then. When I try to launch it now, it stops immediately with these error messages.

- FMS.exe Has encountered a problem & needs to close.

- Error Signature: AppName: fms.exe AppVer: 0.0.0.0 ModName: kernal32.dll ModVer: 5.1.2600.3119 Offset: 00012a5b

- Exception Information: Code: 0x0eedfade Flags: 0x00000001 Record: 0x0000000000000000 Address: 0x000000007c812a5b

Module 1: FMS.exe Image Base: 0x00400000 Image Size: 0x00000000 Checksum: 0x00000000 Time Stamp: 0x2a425el9

Thinking FMS may have gotten corrupted, I tried uninstalling & reinstalling a fresh one - without any luck. I'm at a loss. What's wrong here & how can I fix it?

Help will be much appreciated.

Richard

[HeliEye]

I have the identical problem to the guy above.. very annoying.

Any help would be great

Thx in advance

Steve

[rckowal]

I have the identical problem to the guy above.. very annoying.

Any help would be great

Thx in advance

Steve

Steve, See my latest posts in General Discussions section of this forum. There is a solution there.

Good Luck, Richard

[HeliEye]

All fixed... Gives self big kick, as I didn't have any serial devices when I built this PC, the ports were all 'disabled' in BIOS. Re-enabled now all working fine..woot

Steve

[rckowal]

All fixed... Gives self big kick, as I didn't have any serial devices when I built this PC, the ports were all 'disabled' in BIOS. Re-enabled now all working fine..woot

Steve

That's great, glad to hear that you got it going.

You're not alone without serial ports. None of the newer (commercially built) PC's have them either so this is proving to be a common problem with FMS.

Richard

[smcxx66]

got 2.8 to run my tower finally.
Followed the instructions and it works like a charm
thanks

[rckowal]

:lol: got 2.8 to run my tower finally.
Followed the instructions and it works like a charm
thanks

You're welcome.