Greetings All,
I have a new Belt CP and a FMS sim program Ver 2.0 Alpha 8.3 and ESky 0905A transmitter running on Windows XP.
I have installed the FMS program and calibrated the transmitter but I cannot get the tail rotor, or rudder, to work properly. The problem is that I have no right tail rotor or right rudder movement, zero. Move the stick all the way to the right and there is no tail rotor movement.
And the left tail rotor command is all or none. If I move the stick a degree or two to the left I get full left tail rotor deflection or rudder deflection, there is no proportionality in the tail rotor movement. The helicopter spins to the left at a very fast rate with no control the spin rate.
This problem is evident during the calibration mode also. With channel four stick centered The blue bar for the tail rotor is completely colored blue, move the stick a degree or two to the left and the blue bar goes completely white, move the stick to the right and the bar stays completely blue.
The other three channels work properly.
I have uninstalled and reinstalled FMS, no help. Calibrated and recalibrated the flight controls, no help.
Pretty much stuck now, anybody have any suggestions.
Thanks