GRAUPNER MC-10 - PARALLELPORT PPM INTERFACE CONNECTION

[DAN D MAN]

[B]

1: OPEN UP THE TRANSMITTER AND LOOK AT THE 5-PIN CONNECTION MODULE IN THE MIDDLE.

2: IF YOU LOOK CLOSE YOU SEE 5 METAL CONNECTION PINS WITH NAMES NEXT TO IT.
IT WILL LOOK LIKE SOMTHING LIKE THIS :

PIN1 -0--0---- GND/BN
PIN2 -0--0----
PIN3 -0--0---- VCC/R
PIN4 -0--0----
PIN5 -0--0---- MOD/OR

3: YOU WILL NEED A PARALLELPORT PLUG ELECTRONIC WITH NUMBERS ON IT (FOR PIN CONNECTION IDENTIFICATION).

4: SOLDER A LONG WIRE (200 CM) FROM PIN2 ON YOUR TRANSMITTER TO THE PARALLELPLUG PIN 18.

5: SOLDER A LONG WIRE (200 CM) FROM PIN5 ON YOUR TRANSMITTER TO THE PARALLELPLUG PIN 10.

6: CLOSE THE TRANSMITTER AND PUT THE PARALLELPORT PLUG INTO THE COMPUTER (RUNNING WINDOWS 95/98/ME)
NOTICE ::: WIN 2000 AND XP ARE NOT SUPPORTED. :::::::

7: REBOOT AND RUN FMS.
SWITCH ON YOUR TRANSMITTER
THEN GO TO THE MENU AND SELECT CONTROLS.
THEN CHOOSE YOU LPT1 CONNECTION OR 32-BIT-VXD
AND START CALIBRATING YOUR CONTROLS.
----------------------------------------------------------
IF YOU ENCOUNTER PROBLEMS OR NOTHING HAPPENS
CHANGE YOUR COMPUTERS BIOS SETTING FOR PARALLELPORT CONNECTIONS TO ECP-EPP VERSION (1.9 IS PREFFERED.)
(DO THIS IS ONLY WHEN YOUR CONNECTION DOESNT WORK PROPERLY.)

GREETINGS DAN D MAN © ISD2001.COM