I've got fms and a futaba cable that hooks up to the parallell port. I know that the port is working. I am trying to use a futaba T6XA controller. I can't figure out how to use the controller with fms. Can somebody help?
thanks,
Jason
HELP!
3 posts
• Page 1 of 1
by Rockfist Rogan » Sat May 11, 2002 12:13 pm
I have said this several times before...
a SEARCH would have found it
~~~~~~~~~~~~~~~~
Set your channels 5 -8 to the same numbers as the first 4
For instance I have mine set to:
Rudder 4
Elevator 2
(Right stick)
Aileron 1
Throttle 3
(Left stick)
(These are AIRCRAFT settings)
Tail 4
Nick 2
(Right stick)
Roll 1
Pitch 3
(Left stick)
(These are HELICOPTER settings)
Note that only the first 4 blue columns actually move up and down when calibrating. Don't worry about it!
Ticking exp (exponential) can help a LOT with helicopter flying <g>
HTH
RR
a SEARCH would have found it
~~~~~~~~~~~~~~~~
Set your channels 5 -8 to the same numbers as the first 4
For instance I have mine set to:
Rudder 4
Elevator 2
(Right stick)
Aileron 1
Throttle 3
(Left stick)
(These are AIRCRAFT settings)
Tail 4
Nick 2
(Right stick)
Roll 1
Pitch 3
(Left stick)
(These are HELICOPTER settings)
Note that only the first 4 blue columns actually move up and down when calibrating. Don't worry about it!
Ticking exp (exponential) can help a LOT with helicopter flying <g>
HTH
RR
- Rockfist Rogan
- Posts: 74
- Joined: Thu Feb 28, 2002 9:11 am
by Steve Lewin » Sat May 11, 2002 5:50 pm
- Steve Lewin
- Posts: 816
- Joined: Mon Jun 18, 2001 2:32 pm
- Location: N. Staffs, UK
3 posts
• Page 1 of 1
Return to Parallelport-PPM-Interface
Who is online
Users browsing this forum: No registered users and 7 guests