rc cable

[Shozy]

Hello everyone, We have made a cable that works for FlyRC on the parallel port. Will this cable work in FMS v2.0 beta 6 ? We have tried. It gets a signal, but does not calibrate. This cable is the transistor type not the z-diod type. We have made a z-diod cable and that gets no signal at all. We are using a Futaba Skyport 6. Should the second cable we made (with the z-diode) work on V2.0 beta 6. Have not tried older version of FMS. Any help ?

[Roman Moeller]

If the cable worked with the FlyRC it should also with the FMS. Most probably the Problem is not a question of the hardware, but one of the interruptsettings. So take the old cable that worked and make sure that all the interruptsettings are correct and the interrupt is not used by any other device as for example the soundcard.

[Shozy]

Thanks, I had to disable the "share interupt settings in the sound card properties"....works fine now

[arno]

Hello,

where have you found that setting, i can't find it, I also use futaba skysport

thanks