I purchased CockpitMaster, and it works fine with its supplied parallel connector. FMS simply doesn't see it. I tried everything, but the only interface that FMS 'sees' is my joystick - that functions fine. Would like to use my transmitter though.
Suggestions?
Seems to me that if it works in one program, then the IRQ is not an issue. Hardware is not an issue. Software seems to be, and the software in question is FMS. Is there a setting somewhere, or is this just a gap that needs to be filled in, in the program...
Hitec Flash 5, and parallel? - Interface works in other apps...
4 posts
• Page 1 of 1
by Steve Lewin » Mon May 06, 2002 8:49 am
Sorry but the 2 programs use completely different ways of reading the information from the parallel port. It's not going to work.
Steve
Steve
- Steve Lewin
- Posts: 816
- Joined: Mon Jun 18, 2001 2:32 pm
- Location: N. Staffs, UK
by Steve Lewin » Sun May 12, 2002 8:48 am
- Steve Lewin
- Posts: 816
- Joined: Mon Jun 18, 2001 2:32 pm
- Location: N. Staffs, UK
4 posts
• Page 1 of 1
Return to Parallelport-PPM-Interface
Who is online
Users browsing this forum: No registered users and 2 guests