by Eric Brouwer » Wed May 14, 2003 8:29 am
I will try to assist in english.
- Connect transmitter to parallel port.
- Switch your transmitter on, without crystal.
- Start FMS.
- From menu, select Controls, then Analog Control.
- Select Parallel/Serial IRQ Interface, 32 bit VXD.
- Click on Ressources.
- Under Port, select LPT1, and click Ok.
- Click on Mapping/Calibration.
- Click on Calibrate.
If all is well, you will see the bars moving when you move the transmitter sticks. Follow on-screen instructions.
Map the channels to their correct functions, and if needed, select Inv if movement is in wrong direction.
Good luck.