I downloaded the FMS 7 software with the hope of using it on a Compaq Armada 110 laptop (Celeron 847MHz & Windows ME), with a Futaba FF6 Tx and serial interface.
After tweaking the settings in the DirectX 'DxDiag' software (the laptop has a Trident Cyberblade i1 AGP (51) graphics card as standard) I did have FMS running, albeit with the textures turned off - the frame rate was OK for me and it was fine.
Now however, it doesn't work with the FF6 Tx any more - it's like there's no signal from the Tx at all.
Any suggestions? As far as I can tell the Tx and serial interface cable are fine, and now I don't understand why it worked at first but doesn't now.
Thanks,
Grahame