iI would like to know where i can pick up the tx signal if i have not got a buddy box plug. FUTABA FP-T5NL-H.
The tx is still working great , dont want to fly the poloney slicer till i have tried the remote on FMS.
prolems with futaba old generation
2 posts
• Page 1 of 1
by alexbe » Thu Feb 21, 2002 12:37 am
Hi Pierre,
Take the back off of the TX There are two boards. The lest board is the RF side. A 5 pin connector connects the two boards together. From the top the connections are RF out (to antenna), Gnd,Gnd, Batt V (9.6v), Signal. Connect to GND and Signal. But check first This is from memory.
Good luck
Alex
Take the back off of the TX There are two boards. The lest board is the RF side. A 5 pin connector connects the two boards together. From the top the connections are RF out (to antenna), Gnd,Gnd, Batt V (9.6v), Signal. Connect to GND and Signal. But check first This is from memory.
Good luck
Alex
- alexbe
- Posts: 3
- Joined: Tue Feb 19, 2002 11:24 pm
- Location: Aldershot UK
2 posts
• Page 1 of 1
Return to Serialport-PPM-Interface
Who is online
Users browsing this forum: No registered users and 3 guests