Hello, ive just bougth the FMS program, and there was a remote following with it.
but when i use it on a normal pc its on com port 2 it works without any problems,
but when i try on my own laptop, then the com port is 11, and i cant get that one to work, it the place where you select the com port, it only comes with 1, 3, 4, 5, 6, 7, 8 and another 1?
ive tryed them all and none of them respond when i try to calibrate or any thing.at the ports (com & LPT) its called USBtoCH341 (com11) when its at my laptop, at normal pc its USBtoCH341 (Com2)
When i open my device manager it looks like that, but only at the ports (com & LPT) the only one being there are the USBtoCH341 (com11) <-- my controller
when i use the properties for it i get this window
witch are the same on both computers.
then at the advance you can change its com, but it says all mine are in use, how do i figure out what they are in use for, and how to change them? because i can see some of those on my tower pc but not on my laptop pc.
the laptop is an Acer
my controller is an Art-tech E-fly i think its called it looks allmost like this one http://www.art-tech.cn/english/ArticleShow.asp?ArticleID=135 and its plugged in with an USB.
any one that can help, and do i make any sence in what i wrote?[/img]