connect the Laser4 RC Trainer Jack to microcontroller

[elad_so]

Hello
Is there a way to control Hitec Laser4 Remote Control from micro controller?
Anyone ever did that?
Basically I want to control the laser 4 from micro controller
And the laser 4 will transmit by RF signal the commands to my car vehicle.

can I connect the microcontroller to the trainer jack and control the remote control from there?

Any help would be appreciated

[Steve Lewin]

Yes it is possible to do that if you know what you're doing. Your microcontroller must send the "trainer" signal that would normally come from a slave transmitter in training mode.

But you're in the wrong place to ask about this.....it doesn't have anything to do with the FMS simulator. Try somewhere like RCGroups www.rcgroups.com Computer control of RC transmitters has been discussed many times in the DIY Electronics forum.

Steve