reverse controls - opposite sticks with futaba

[ben]

[Eric Brouwer]

You need to set the channel mapping to the correct function under the Mappping/Calibration section.



If a channel is working the opposite way, select that channels "Inv" option to reverse the signal

[ben]

Hey thanks man, this did the trick. I had read several other settings but they were not quite right; these are. All I had to do was reverse one of the channels and now I can actually fly. Maybe I should say could in stead of can as I am still doing a fair bit of crashing but that is my lack of skill. Thanks again Eric.

Ben

[Eric Brouwer]

If your model is too sensitive around the stick centre, you can also select the "Exp" option for the specific channel. This will give exponential servo movement. This makes the "servos" move less at the mid point, but still allow full movement at the stick ends.