Newbie - What I've Learned

[grafen]

I had a lot of problems with the interface between transmitter and FMS. I finally resolved the issue; I hope this helps other novests.

1. The install disk contains three other files (in Chinese) that are video files. Although not in English, they are very helpful.
2. Before you install the FMS, connect the transmitter via the Softdog USB cable. You can confirm its working by going to "Control Panel" Other
Hardware - Joysticks. Note: Transmitter Pwr Switch should be "ON".
3. Install the FMS with the Transmitter connected and turned on; otherwise, the FMS won't recognize the Transmitter.
4. In FMS configure the Transmitter (refered to as Joystick) following the settings in the video that shows setting up the Transmitter. Calibrate your Transmitter.
5. Happy flying.