Dynam 6 channel servo reverse??

[Richardkb]

I just recieved a Dynam FMS simulator (6 channel) and downloaded FMS 8.5 from this site. The system works
well with exception that the elevator function works in reverse. Is there any way to reverse the elevator
servo through software? I opened the Dynam simulator and found the elevator pot wires do not plug into the
circuit board, so I can't reverse the connection unless I cut and resolder. Thanks!

Richardkb

[Steve Lewin]

Mapping/Calibration screen - just tick "INV" (Invert) against elevator.

Steve

[Richardkb]

Thank's Steve--should have been obvious! Working well and I switched
to 2.0 7 for the better landscapes and model selection.