I have the Century USB Simulator Controller and the FMS 2.0 Alpha 8.5 program. I have a Dell computer using Windows XP SP3 and a Pentium (R) D processor. I have gone through the setup a few times including the calibration. Channels 1,2,3, and 4 seem to move fully. When I try to fly the airplane the up elevator control does not raise the nose and it usually ground loops, and crashes , never flying. Is there a diagram on what to set the other controls/sliders to besides the throttle and joy-stick and what they trim? In the mapping/Calibration diagram, what boxes should be checked in the "Inv" and "Exp" columns next to the Channels column? The example shows only the rudder and tail boxes checked in the Inv column. What does Inv and Exp mean?
I have tried to remove the program and reload it but I get two error messages. 1. the HW_VSP.exe is still there and can't be written over, and 2. The same with windows\system32\ VSPort.dll file. Can I just go in and delete these files manually or can I get in trouble taking out an windows file?
Any suggestions would be greatly appreciated.