Wait, ITS FIXED!!! ITS FIXED!!!. Its like %100 jitter free now! I did more than just norton fixing up my computer. Remember when i said it wouldent work for some reason on the 32 bit VXD? Well, i went to try again. the reason it didn't work is because I had to set up my controls! they wernt working because the controls for the helicopter were set on channels I didn't have(6), (7), (8) and (9). Mine only goes up to 4. so I set it to the channels I did have(1), (2), (3), and (4). I didn't know this becasue I assumed they would keep the same channels as the 16 bit DDL, which i had them set on my channels. its runs like a beauty now! I can finally hover properly with no jerky or nervous movments! you guys should see the bars on the calabration gird. their not even moving! before, they were jumping up and down like crazy and vibrating allot, now their perfectly holding still! Im so happy!!!
it took me days to figure out a way to fix this problem. i was spending hours each day doing it. finally it works! Im still a little worried it will start back up again though. because I still have the parellel printer port interface which i though all along was my problem because everybody says the printer port picks up allot of interference and jitter. so how come its not doing it now? is it because its now set on the 32 bit VXD instead of the 16 bit DDL? i really hope it will stay like this and the jitter will not return. because if it does, i will punch a hole in my computer screen
. It will stay like this right? what about the so called problems with the pinter port interfaces with interference? how come nobody ever suggested the 32 bit thing first?