PCM Radio and FMS - What interface is needed for a PCM radio

[PuffSixGun]

Hi. I have a Futaba PCM transmitter. To run FMS, what type of interface would I need?

I have Windows 98 and Windows XP on seperate computers.
The radio transmitter is a Futaba FP-T7UHP Super PCM 1024.

Any assistance would be greatly appreciated!

Eric

[Cuban Flyer]

[PuffSixGun]

[Silly me]

Copy the winmm.dll in to the FMS installed dir, you'll be able to fly FMS via your mic port on the sound card.


SmartPropo is the software to use your R/C TX (Futaba, Jr, or other 1024PCM TX) as a joystick controller on your flight simulators and so on. This is realized by connecting thm to the audio input on your PC.

Especially, Jr TX has monoral mini-jack as a signal output, hence, you may be able to use an audio cable sold at stores.

Although if your TX is Futaba, it is easy to convert a DSC cable into SmartPorpo cable. It's enough if you can do soldering, you don't need any special electronics knowledge. More easily, you can use conversion cable for RealFlightG2 (genuine Futaba parts) with T9Z TX.




for more info

[PuffSixGun]

Thanks for your reply. I will check this out too.

Eric