Models will not fly in FMS

[Z]

[Steve Lewin]

[sitichon]

[ggunners]

[ozzy]

[ruka]

I'm having the identical problem than Sitichon . Any model into the model folder does not fly. It loads up with engine running, but none of the channels do anything, the plane just sits there on the runway. Whem try to calibrate, I detect controler but re-calibration has no effect. I am running with Beta 2.0 vs 7, but have tried earlier version with no difference.

I have wibdows vista and esky cable in a JR 9X transmiter.

Thanks in advance

[Steve Lewin]

Try reading the post immediately following Sitichon's message.

Steve

[ruka]

Thanks Steve!
I have another problem: my JR is working now the throtle with right hand. How can I change it?

Thanks again.

[ggunners]

[phildc]

And, before the question arises again, the 4 upper(channel) numbers are for planes, the 4 at bottom are for helis (just do a copy of the 4 at top, in same sequence).
Don't ask why it was designed this way, it is just a fact .

Always do your first tests with a plane, it is easier. With an helicopter you have less chance to understand what happens.

Test in this sequence, and correct INV (or channel, you never know) if necessary:
throttle (reduced) to start taxiing, rudder to turn left/right when taxiing, elevator pulling to take off when going at enough speed, ailerons to make a roll when in the air.

Phil.


sim simulator flight fms setup set up tutorial adjustements radio rc model transmitter stick lever channel number inv exp how to howto explain

[ruka]

Thanks a lot to all that helped me.
I did with chanels 4/3/2/1 .

Thnaks a lot again.