I have some questions about the program.
1. What does the "Exp" function do in the calibration window? I can't see any difference when I check and uncheck the boxes.
2. I use beta 7. Why doesn't the "smooth textures" function work, when it works fine in beta 6?
3. I have an AMD Athlon MMX 3DNow 1400 mhz, 256 mb ram, GeForce 2 graphics card, running Win98 and DirectX 9. But when i run the program (beta7) in 800x600 full-screen mode, I only get 7 fps! Is that normal??
If I use the 1024x768 full-screen mode, it runs even slower.
4. When I have booted up my computer and try to run FMS, it won't start. It just reads from the harddrive for a few seconds, then nothing happens. But the second time I try to start FMS after a boot-up, it works fine.
It's the same thing with both beta 7 and beta 6. This isn't really a problem since I always can get the program to run the second time I try to start it, but it's strange that it's acting this way.
Finally I would like to say that I have built myself the serial version of the interface and connected it to my Futaba FC-16. The FC-16 has no "trainer-out" socket, so I had to connect the cable directly to the IC-circuit inside the transmitter. But it worked fine!