running FMS 2.0 b7 on a win98.
Calibration works fine all the time & usually a quick click on a menu, or going back into the controls & out again (without doing anything) will return control for another 5 seconds or so.
Any ideas?
intermittent controller problem - Hitec Laser 4 & PIC serial stop working
1 post
• Page 1 of 1
by groundhugger » Thu Jul 08, 2004 1:17 pm
My Hitec Laser 4 with PIC serial interface stops working after about 5 seconds of flight - or takeoff usually running FMS 2.0 b7 on a win98.
Calibration works fine all the time & usually a quick click on a menu, or going back into the controls & out again (without doing anything) will return control for another 5 seconds or so.
Any ideas?
running FMS 2.0 b7 on a win98.
Calibration works fine all the time & usually a quick click on a menu, or going back into the controls & out again (without doing anything) will return control for another 5 seconds or so.
Any ideas?
- groundhugger
- Posts: 1
- Joined: Thu Jul 08, 2004 1:06 pm
1 post
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 13 guests