Hi, FMS will not allow me to cinfigure my port settings in the 16 or 32 bit serial port mode with Win XP. Any ideas? I am running the latest ver of FMS. It ran great on my Win 98 setup. I saw the Alpha (In the "developement" section) file but I'm not clear on how to to get it into the right place in the program. Any and all help would be great.
Thanks,
Eric.
E713@aol.com
FMS/XP - TX Config
2 posts
• Page 1 of 1
by Eric Brouwer » Sun Dec 08, 2002 6:19 am
WinXP does NOT support the serial PPM interface, as WinXP/WinNT dropped support for the RING pin on the serial ports.
For WinXP, you will require a serial PIC interface or joystick interface. See my webpage for some links to interfaces.
For WinXP, you will require a serial PIC interface or joystick interface. See my webpage for some links to interfaces.
Some mistakes are too much fun to only make once.
Vanderbijlpark
South Africa
Homepage: http://myweb.absa.co.za/eric.brouwer
Vanderbijlpark
South Africa
Homepage: http://myweb.absa.co.za/eric.brouwer
- Eric Brouwer
- Posts: 252
- Joined: Mon Apr 22, 2002 7:53 am
- Location: Vanderbijlpark, South Africa
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 27 guests