I made an interface (680R resistor+ 4.7v diod),
I get in pin 10,18 ppm signal (tested with a scop) but in the FMS clibration menu I recive "no signal" massage
I need any informtion or help to check my self .
Thanks...
Parallelport-ppm-interface - help for interface-Sanwa-Excellence
3 posts
• Page 1 of 1
by Steve Lewin » Wed Jul 18, 2001 10:46 am
Is the voltage swinging the full 5V. What transmitter are you using ? Some Txs have only a low voltage out on the trainer socket ?
Is your parallel port set to ECP or EPP mode ?
Have you entered the port Address and IRQ correctly ?
The interfaces that use a transistor for switching often seem to work better than the very simple one.
HTH - Steve
Is your parallel port set to ECP or EPP mode ?
Have you entered the port Address and IRQ correctly ?
The interfaces that use a transistor for switching often seem to work better than the very simple one.
HTH - Steve
- Steve Lewin
- Posts: 816
- Joined: Mon Jun 18, 2001 2:32 pm
- Location: N. Staffs, UK
by hr » Sun Jul 22, 2001 2:47 pm
Thanks Steve for your unswer,
I am using the AM SANWA EXCELLENCE 6 transmiter.
I tested the interface in mode ECP and EPP but I still
get now signal message.
It will be helpful for me if you can inform me how should
be look the signal in the paralleport in put (pin 10,18)
so I can test it with ascop.
Thanks , HR
I am using the AM SANWA EXCELLENCE 6 transmiter.
I tested the interface in mode ECP and EPP but I still
get now signal message.
It will be helpful for me if you can inform me how should
be look the signal in the paralleport in put (pin 10,18)
so I can test it with ascop.
Thanks , HR
- hr
- Posts: 2
- Joined: Tue Jul 17, 2001 12:27 pm
3 posts
• Page 1 of 1
Return to Parallelport-PPM-Interface
Who is online
Users browsing this forum: No registered users and 12 guests