esky 3d on com port - calibration working in fms

[giles25]

[Steve Lewin]

[giles25]

[Flyheli?]

Do you have any other controllers plugged in? I had the same problem, I unplugged my usb flight joystick and gamepad and restarted FMS with PPJoy running Zhen Hua 5 byte protocol set channel order to 64356435 and and reversed the throttle switch on the transmitter and it works. I hope this helps
P.S. I am running Windows XP and FMS Alpha 8.5

[giles25]

thanks i'll try that

[giles25]

sorry that didnt work either. Flyheli what com port settings are you using? its seems that no matter port settings i use makes no difference as in ppjoy still picks up the signal no matter what i do.

[Flyheli?]

Giles25 my port settings are:
COM port 1
Bits per second = 19200
Data bits = 8
Parity = None
Stop Bits = 1
Flow control = None

You might also want to check out this forum

There's a bunch of info in there about this type of controller and FMS. Good Luck.

[giles25]

thanks for advice, but still no joy. Ill try the controller on another computer to see if that makes any difference. My pc can be a bit random at times, its been a while since i did a clean install.