Hello All,
Can someone please help me.I have FMS & a new JR X-2610 transmitter.I bought a new interface cable with FMS.
I plug it inot com 1 or 2 & run the software.Cannot get any response from the calibration screen....
The cable is serial at one end & like head phone jack the other.Running XP with an late model computer..FMS runs fine on keyboard just no response from TRANSMITTER..
Can some one please help me.
JR WATTS
DOWN UNDER AUSTRALIA
praveenj@ozemail.com.au
HELP PLS : JR X-2610 LINK FMS PROBLEM - INTERFACE PROBLEM
2 posts
• Page 1 of 1
by Eric Brouwer » Mon Jun 07, 2004 12:56 pm
How about sticking to only one forum?
Please see the replies at . I send you a private message as well as email, but did not get any reply back from you.
Please see the replies at . I send you a private message as well as email, but did not get any reply back from you.
Some mistakes are too much fun to only make once.
Vanderbijlpark
South Africa
Homepage: http://myweb.absa.co.za/eric.brouwer
Vanderbijlpark
South Africa
Homepage: http://myweb.absa.co.za/eric.brouwer
- Eric Brouwer
- Posts: 252
- Joined: Mon Apr 22, 2002 7:53 am
- Location: Vanderbijlpark, South Africa
2 posts
• Page 1 of 1
Return to Serialport-PPM-Interface
Who is online
Users browsing this forum: No registered users and 1 guest