FMS Forum

by **deonvdw** » Wed Feb 11, 2004 5:32 am

now supports this TX via the PPJoyCOM mini-driver.

Regards,
Deon

by **Heli-va RC** » Wed Feb 11, 2004 6:32 pm

PPJoy will configure the PARALLEL port for Zhen Hua TX. I have contacted Deon to see if it will work with the serial port as well. I'll keep ya posted.

by **deonvdw** » Mon Feb 23, 2004 4:28 am

PPJoy does not use the parallel port for the Zhen Hua.

PPJoyCom (part of the larger PPJoy package) reads the Zhen Hua data stream from the serial port and passes it on to a virtual joystick created by PPJoy.

Regards
Deon

by **Barracuda001** » Fri Apr 16, 2004 10:28 am

Sorry for being a complete noob, however I have a Zhen Hua PCm-4ch transmitter. I have installed ppjoy and connected the tx to the serial port (configured as COM1). However when I try and callibrate the virtual joystick nothing seems to happen.

Would someone be able to give me a step through the configuration process pls...

by **Montana** » Mon May 03, 2004 2:41 pm

hello i had the same problem ! have the ZHEN HUA PCM-4CH
with PP-Joy it will work ! all you have to do is install PP-Joy then you open the PP-Joycom ! and choice the protokoll for ZHEN ! then you open FMS (PP-Joy must be open in the background ! you choce joystick and then you must set the 4 4 chanels on the right numbers ! it will work ! if you dond know how to do it then ask me again i will make screenshots for you !

by **Ken Hewitt** » Tue May 04, 2004 11:36 am

I have been asked to do a special version of the PIC Serial interface to use with this transmitter, it will be sold by when it is ready.

Ken.

FMS Forum

Zhen Hua PCM-4ch transmitter

Who is online