by adamsc » Tue Aug 27, 2002 8:03 pm
I had a similar problem when I built a PIC serial cable. I'm using a Hitec Flash 5x. I was trying to fly the Zagi model and it kept banking left and down. I finally figured out that I had to set up FMS for my TX, which is on Elevon Mixing (for the Zagi). Go into the Controls menu, then choose Mapping/Calibration. I actually had to change Rudder to channel 4, Elevator to channel 2, Aileron to channel 1, and Throttle to channel 3. I also had to check the Inv box on Aileron. Yours may be different, so a little experimenting may be in order.
Hope that helps!