Hi All,
I am looking for the protocol description for the serial/pic (non-irq) interface. I would like to build my own interface and could not find a description of it on the FMS web page. Any help would be apprecialted!
Thanks!
:0
Looking for the serial protocol - Interested in building my own interface
3 posts
• Page 1 of 1
by Steve Lewin » Tue Feb 17, 2004 5:24 pm
If you've installed FMS try looking in Doc/Interface. There's a description of the PIC serial protocol in readme_en.htm It's pretty simple.
Steve
Steve
- Steve Lewin
- Posts: 816
- Joined: Mon Jun 18, 2001 2:32 pm
- Location: N. Staffs, UK
by overhead » Wed Feb 18, 2004 3:52 am
FMS PIC Serial Protocol.
The protocol for the 19200 baud is the easiest.
First send "FF" then send channnel 1 "value", then channel 2 "value", continue until all channels sent. Channel value range is 00 to FE. FF indicates new frame of data.
Repeat above til done.
Dennis
The protocol for the 19200 baud is the easiest.
First send "FF" then send channnel 1 "value", then channel 2 "value", continue until all channels sent. Channel value range is 00 to FE. FF indicates new frame of data.
Repeat above til done.
Dennis
Dennis
- overhead
- Posts: 55
- Joined: Wed Apr 17, 2002 12:49 am
- Location: Winnipeg, Manitoba, CANADA
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 5 guests