I am building the PIC serial interface but I don't know which PIC12C508 to order?? There are part numbers: PIC12C508T-04/SM, PIC12C508T-04E/SM, PIC12C508/JW, PIC12C508/SC, etc. Which part number is used for the PIC interface???
Thanks,
Tom
PIC12C508 which model - Which model PIC12508 do I use.
2 posts
• Page 1 of 1
by FockeWulf190d9 » Thu Mar 07, 2002 11:00 pm
- FockeWulf190d9
- Posts: 1
- Joined: Thu Mar 07, 2002 10:30 pm
by Mike Roberts » Sat Mar 09, 2002 9:41 pm
Tom
You can use any of them - but note that it has to be programmed. Microchip have designs on DIY programmers if you do not want to buy one. The 'JW' device is an erasable version used for program development. The others are OTP (one time programmable) - so you get just one chance to program it right. 'SM' is surface mount, 'P' is DIL etc.
If you want aready built PIC interface go to my website on and to RC Projects>FMS. I also have detailed setup instructions there.
Mike
You can use any of them - but note that it has to be programmed. Microchip have designs on DIY programmers if you do not want to buy one. The 'JW' device is an erasable version used for program development. The others are OTP (one time programmable) - so you get just one chance to program it right. 'SM' is surface mount, 'P' is DIL etc.
If you want aready built PIC interface go to my website on and to RC Projects>FMS. I also have detailed setup instructions there.
Mike
Mike email: mike@customelectronics.co.uk web:
-
Mike Roberts - Posts: 190
- Joined: Sat Nov 17, 2001 10:08 pm
- Location: UK
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 8 guests