FMS joystick configure jitters

[rasm0208]

I have the latest FMS and SmartPropoPlus installed and when i go to configure my Fx (which is connected through the mic port) in FMS all of the channels are jumping up and down and not moving accordingly to my movements. When out of the config screen the plane is spazing out as if its getting very quick changes to all channels. Is there anyway to fix this? Thanks

[shaul_eiz]

I need you to be much more specific. Which Tx exactly are you using? How did you create your cable? Did you try to calibrate FMS?

[click1]

Hi there.

I seem to have exactly the same problem

I have connected Walkera's 22E remote using same SmartPropoPlus interface and first six channels inputs are all over the place when I try to calibrate...

I am using mono 3.5mm jack on one side and that S-Video on controller's side. I can play with positive/negative polarity (and it really depends on how I wire ground and signal - if I select manual and wrong polarity I get nothing). Also, I have tried sound recorder and what I am getting there kind of looks OK (I wouldn't know if it is right or not). It looks like as a signal.

I have tried Generic PPM and that is (I think) only place where I am getting something.

Does anyone have any idea what am I doing incorrectly or how to debug it further?

There is one more small detail I would like to keep hidden at the moment so nobody is biased and/or mislead by it

[shaul_eiz]

Hard to tell without seeing the sound recording.
Maybe the signal is too weak, maybe too strong.
Are you sure that it is PPM? Some Walkeras are PCM.
Anyhow - to the best of my knowledge, SmartPropoPlus was never tested with Walkera CCPM (Only with E-Sky).

[click1]