0406A tx problems

0406A tx problems

Postby Bauers007 » Fri Jul 11, 2008 10:03 pm

I'm having problems with my transmitter working with the program. When i move the throttle up, the elevator goes down and the aileron slider moves up with the throttle. ive used different configurations of mapppings, and it does the same thing..
Bauers007
 
Posts: 2
Joined: Fri Jul 11, 2008 9:56 pm

Postby Steve Lewin » Sat Jul 12, 2008 7:51 am

FMS calibration screen, look which blue bar moves when you move each control....then put the number of that bar in the appropriate place on the LH side of the screen. I.e. if bar 1 moves with throttle, put 1 against throttle. Repeat for all controls.

Steve
Steve Lewin
 
Posts: 816
Joined: Mon Jun 18, 2001 2:32 pm
Location: N. Staffs, UK

Postby Bauers007 » Mon Jul 28, 2008 1:53 am

well, i dont have a problem assigning the inputs, its just that i cant isolate the signal. since the aileron is effected by the throttle input, i'll be flying a heli, and it will want to move right the more i increase the throttle. it's like the lines are getting crossed. any ideas?
Bauers007
 
Posts: 2
Joined: Fri Jul 11, 2008 9:56 pm

Postby Steve Lewin » Mon Jul 28, 2008 8:40 am

Sorry, I though you were saying the wrong control moved....not that several controls moved TOGETHER :(.

Sounds like you have CCPM mixing in the transmitter. It may be possible to switch it off but I don't know that transmitter (or anything about helicopters).

Steve
Steve Lewin
 
Posts: 816
Joined: Mon Jun 18, 2001 2:32 pm
Location: N. Staffs, UK


Return to Joystick-Interface

Who is online

Users browsing this forum: No registered users and 7 guests

cron