Also no calibration

[bertbear]

I love the shareware, thank you for all your work on this. I am having a similiar problem to the one .

I just set up a cable between my radio and PC. The PPM thermometer shows signal, no problem, but the calibration routine in FMS does not show any movement. On the resources tab, the bars on joystick 1 are lit, but no movement. I was able to set the debug key in the registry, and the log files were generated, but not sure what to do with the data.

FMS 2.0
Smartpropo plus 3.3.0
Futaba T4EXA connected through line in.

Toshiba P25-S507
2.8 Ghz P3 Hyperthreading
WinXPSP2 Home

Thanks for any help that is offered.

[shaul_eiz]

Let's see what we have here:
The thermometer is OK - meaning the PPM signal arrived safely at the PC's audio system.
Does the thermometer still function when you start FMS? If not, SmartPropoPlus has redirected the PPM signal to an incorrect audio source. Fix that either by selecting the correct audio source or by un-checking Enable Audio input selection. Now, when FMS+SPP are both on and the thermometer is functioning again, can you calibrate FMS?
If not, have you correctly selected the modulation type? It should be PPM (Generic).

[bertbear]

The thermometer does still function when FMS starts. Selecting another audio source, or un-checking Enable Audio stops the thermometer function. The thermometer functions with with ALL modulation types and polarities, and FMS shows no reaction. Debug messages popup with each change in type and polarity.