Just completed two new FMS 2 alpha 8.x models. The first one
is a fun little 3D flyer using a CD-ROM motor that is a blast
to build and fly called the 4F-51 from genebond over in the
Foamie's forum.
Model: Genebond's 4F-51, Fat, Flat, Floppy, Foamy
Author: Gary Gunnerson
Email: garyg51384@aol.com
HomePage:
Created: July 2005
RCGroups Build Thread:
Specs:
Wing Area: 24" x 12" wing + 4" elevons = 384 sqin
Flying Weight: 6.5-7 oz
Wing Loading: 2.7 oz/sqin
Motor: 15t CDR, 8x4HD prop
Battery: 2s830, 7.6a, 53w
Thrust/Speed: 9.7oz thrust, 29mph
Radio: 4 channel, elevon, rudder, throttle
Fun Little 3D Flyer that will also land on it's tail at about
half throttle. It's a lot of fun to build and fly.
You can download the 4F-51 model .
The second model was requested by another flyer to train on
while he's saving up some dollars to buy the 4 channel
Parkflyers Begin-Air. This FMS rendering flys very close
to the videos on the Parkflyers site.
Model: Begin-Air
Author: Gary Gunnerson
Email: garyg51384@aol.com
HomePage:
Created: July 2005
Notes: With help from another Begin-Air owner who took photos
of their airplane, we were able to render this version of the
Parkflyer RC model. This is a true 4 channel RTF airplane at a
very reasonable cost.
Span: 41 inches
Weight: 23 ounces
Motor: 480
Batteries: 1000 mAh Nimh
Radio: 4 channel transmitter included
Parkflyer web site:
RC Universe review:
You can download the Begin-Air model .
Hope you enjoy flying them as much as I did building them.
-- ggunners
