by 4 stroken ron » Sun May 01, 2005 2:09 am
I got an serial interface from milehighwings. I have downloaded and am running 2.0alpha8.5. it all works very well for about 5 minutes or so, then locks up the computer tight, or the screen goes black and I get a message "signal frequency is out of range, please change signal timing". The only thing I can do is a hot shutdown, reboot, and start over. It does seem to run a little longer if I run in "window" mode. I have XP pro, a nvidea G force 5700le 128 card with the lastest driver. I have an old (I do not know how old) MITSUBISHI 91TXM monitor. Could my old monitor be a problem? I run AFP pro and a lot of other stuff on this computer and it all works just fine.
Is there a way to stop this lock up thing?
Thanks for any help.
Ron