extra par - can someone change it

[jodel boy]

can someone please change the par of this extra

it spinstoo much and it runs out of up elevator i tried to chage it but it just made it worse

[helirudi]

Hi,
why don't you just make a copy of the file Pitts.par, rename it to Extra300.par and enjoy flying ?

[ggunners]

[jodel boy]

[jodel boy]

[Jürgen N.]

If you would explain the problems you have it would be much easier to help you.
Kind regards
Juergen

[ggunners]

With both the .par file editor and FMS open and running.

Step1) Make small adjustments to the .par file, then save the .par file with the .par editor.

Step2) Then move to the FMS window and <Reload> the model so FMS will read the new .par file.

Step3) Check how the model flys and make additional adjustments as required. by repeating steps 1 and 2.

-- ggunners

[ggunners]

jodel boy,

I took a stab at modifying the .par file and there's a copy out on my website for a short time at . Just right click and "save target as" to save the .par file.

I think you'll find though that this model continues to spin very fast when both aileron and elevator are used simultaneously. Short-tailed airplanes behave differently than long-tailed ones. In fact, if this 3D model is accurate, you can spin this plane using the elevator only.

If you use only aileron, it spins much more slowly.

I also changed the POLAR to be the same as the SU-26.

-- ggunners

[jodel boy]

i tried it out it was good except you still run out of up elevator which is annoying cause its hard to pull up out of a spin but its alot better than the last one

thanks steven:)