FMS Forum

by **ALANXP** » Thu Jul 21, 2005 11:50 am

I have a interface and I cant fly helicopters.i have futaba 6exa.

by **shaul_eiz** » Thu Jul 21, 2005 12:50 pm

If you have the 'Super' version of 6EXA, then make sure you are not on the PCM mode, or use the PCM version of the DLL.
Anyeway, use the latest version of smartpropo, posted on this site homepage.
Please let me know if problem was solved.

by **ALANXP** » Thu Jul 21, 2005 7:10 pm

My radio is 6exa not 6exas. ???

by **shaul_eiz** » Thu Jul 21, 2005 7:31 pm

Good, so it should be a PPM transmitter.
You have to make sure your cable is the correct one and that you plug it to the correct soundboard input.
You should hear a loud noise in your speakers if the above is OK.
Now, copy the correct winmm.dll file from the package posted on the FMS home page according to the read me file that is also attached to this packege.
Start FMS and select the Controls->Analog Controls->joistick interface then click on button "resources".
Do you see Joystick 1? Does is say something like SuperSmartPropo? Then FMS recognized the software.
Click OK and then on "Mapping/Calibration".
Let me know if you are OK or where you are stuck.
Good luck.

by **Eric Brouwer** » Fri Jul 22, 2005 7:39 am

by **ALANXP** » Fri Jul 22, 2005 8:35 am

by **ALANXP** » Tue Jul 26, 2005 1:44 pm

which stick is to move tali,nick,roll,pitch.mode 2 tx

by **ALANXP** » Thu Jul 28, 2005 7:50 pm

by **Steve Lewin** » Thu Jul 28, 2005 8:02 pm

by **ALANXP** » Sat Jul 30, 2005 7:16 am

by **ggunners** » Tue Aug 16, 2005 12:11 am

in the picture above,

the top 4 are labeled "Airplanes"

the bottom 4 are labeled "Helicopters"

-- ggunners

FMS Forum

helicopters

Who is online