Serial interface won't work with Beta 7? - Interface worked fine with v6 but not v7

[ebourlet]

I just downloaded beta 7 but my interface won't work now. Any Ideas? I can not get it to calibrate. Its on comm 2

[ebourlet]

Sorry , I did not have it set up right. Thanks guys beta 7 is great! I was not able to have the sound on in beta 6 because it caused the models to fly poorly. Beta 7 works great! Thanks again

[PapaBear]

how did u fix it?
i have the same problem.

[wassermann30]

nabend all...

erst mal ein dickes lob für den FMS echt klasse..weiter so!

habe allerdings das gleiche problem mit der seriellen schnittstelle aber der FMS6 funst

[wembley]

Hy!

bin ebenfalls überrascht vom 7.0, geht echt fein!!! hatte das selbe Problem... wenn man jedoch das GAME PORT deaktiviert, dann findet auch der 7.0er den Sender!

Holm und Rippenbruch
wembley

[Loyd Carter]

I have the same problem. My Futaba T6XA worked fine with 6 but I can't get anything on 7.

Pass the info along on how to fix it.

Loyd

[Mike Roberts]

There are two options for the serial interface software. I found that the 16-Bit-DLL worked much better than the 32-Bit-VXD.

I have put detailed setup instructions on my website. Go to R/C projects>Flying Model Simulator interface>Serial setup


Mike

[Rene Nieuwenhuis]

I have the same trouble Beta 6: no problem; Beta 7: crashing the soundcard/gameport. I made a configuration where I disabled the gameport, but that did not fix it. I run it on Win98 SE. Anybody a good idea?

[emo]

Does the serial-interface work on XP on Beta7?

I cant get the buttons "Resources" or "Mapping/Calibrate" to be enabled when I select Parallell/serial IRQ-interface, neirher 16-bit nor 32-bit.

The interface is connected to Com2 - the com-port works just fine, ive also tried com1 without any other result.