Alll done... But it doesn't work - Alll done... But it doesn't work

[paulo]

I have downloaded FMS, installed, connected a lent cable on paralel port (I don't know if it's working. how can I know?), configured the control with:
16-bit-dll ->
I/O: 378
IRQ: 7

All done... But it don't work.
Could someone help me?

Thanks
Paulo

[Steve Lewin]

Could you be a bit more precise than "don't work" ? What exactly doesn't work ?

Have you calibrated the interface ? Do you see anything in the Mapping/Calibration window up window ? Are the blue bars moving at all ? What transmitter are you using ? Is it switched on ?

You'll have to give us some information.

Steve

[Mike Roberts]

Paulo
I have put detailed set up for my serial interface on my website . The same will apply for the parallel. Check you have the correct address and IRQ settings.

Mike

[rainman]

also, i had a problem with mine. make sure you go into system settings and under your sound blaster (if you have sound blaster) uncheck the box that says "enable irq sharing" . after i did that mine worked perfectly. if you need more specific instuctions on how to do that just email me at thanatos@abcs.com and i'll explain.