e-flight setup 6-channel

[theecoop]

I purchased the cable from


USB V.4 Interface (INPUT/OUTPUT MODE) E-flite Blade CP/CPPro/Twi
which tells you to remove chip from tx(radio)

then using FMS control/analog control /joystick interface
click on mapping /calibration set the following mapping
Rudder 6
Elevattion 3
Aileron 1
Throttle 2
Tail 6 EXP Checked
Nick 2 EXP Checked
Roll 1 Exp Checked
Pitch 3 Exp Checked

then center everything on radio then calibrate follow FMS instuctions....
Flys great Now..
Hope this helps someone out.
Theecoop
Blade CP PRO[/url]

[phildc]

[theecoop]

[quote=



Nick should be the same channel as Elevation, and Pitch same as Throttle.

Phil.[/quote]

I'm just showing the mapping I had to use to make FMS and 6 -channel cp pro radio to work for the heli's