Hi
Need help again, why does my helicopter I’ve built when landing land on its belly instead of its skids? The skids go through the ground
Griffo
Metasequoia - Helicoper
2 posts
• Page 1 of 1
by shinichiro » Thu Sep 26, 2002 3:54 am
Hi,
Your model may be in too much lower and go into the ground.
Try my advice;
Move your model upward in Metasequoia and out put as an X-file.
This will set your model upward in FMS, and avoid crash into the ground.
And the following is the right way to fix the problem.
Rewrite every PosZ number in the par-file.
They are the distance between CG and the ground on each points of bottom of the model.
So, make the numbers longer to lift the model up word.
The first way is easier. I recommend this.
Shinichiro Nishiya
Aomori city, Japan
Your model may be in too much lower and go into the ground.
Try my advice;
Move your model upward in Metasequoia and out put as an X-file.
This will set your model upward in FMS, and avoid crash into the ground.
And the following is the right way to fix the problem.
Rewrite every PosZ number in the par-file.
They are the distance between CG and the ground on each points of bottom of the model.
So, make the numbers longer to lift the model up word.
The first way is easier. I recommend this.
Shinichiro Nishiya
Aomori city, Japan
- shinichiro
- Posts: 15
- Joined: Wed Sep 19, 2001 1:46 am
- Location: Aomori city Japan
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 4 guests