hallo
ich habe mir lt. anleitung ein serielles interface für meine fernsteuerung graupner mc16/20 gebaut.
nach einstellung von port und irq hat sich der zustand von "kein signal" auf "signal verbunden" verändert - so wie es sein sollte.
bei der kalibrierung ist es allerdings unmöglich eine brauchbare einstellung zu erreichen. alle paar sekunden tritt ein starkes störsignal auf, welches alle angezeigten kanäle erheblich beeinflußt.
ich habe bereits einige maßnahmen (abschirmung, kürzeres kabel) ergriffen, um die störungen zu beheben. leider hatte ich damit keinen erfolg.
Hier also meine frage:
hat oder hatte jemand ähnliche probleme oder gibt
es vielleicht jemanden eine lösung hat ?
ersuche um antwort
walter