I recently purchased a BlackMax PIC serial interface to use with my Futaba Skysport 6A. I'm using win 98 and beta 7 version of FMS. When I go to calibrate the controls are not reconized, at least it does and says nothing. I have made sure that the channel asignments are correct (mode II).
In troubleshooting I also downloaded Eric Brouwer's interface tester. I get plenty of jumping around of data but at times the "No signal present" comes on. I have the transmitter on during these calibration runs. I have also tried my Hitec Flash 4 and Hitec Eclipse 7 with no luck. Is this a bios problem and if so what do I change? How do I check the outputs of the interface?
Thanx!