by Eric Brouwer » Thu Jun 26, 2003 6:21 am
First, check your BIOS. With the parallel port interface you need to setup the parallel port to ECP/EPP in the BIOS first.
Then, in FMS, set up the controller as follow:
- Connect transmitter to parallel port.
- Switch your transmitter on, without crystal.
- Start FMS.
- From menu, select Controls, then Analog Control.
- Select Parallel/Serial IRQ Interface, 32 bit VXD.
- Click on Ressources.
- Under Port, select LPT1, and click Ok.
- Click on Mapping/Calibration.
- Click on Calibrate.
If all is well, you will see the bars moving when you move the transmitter sticks. Follow on-screen instructions.
Map the channels to their correct functions, and if needed, select Inv if movement is in wrong direction.
Good luck.