I'm starting to see progress with ppJoy on Windows Server 2003. It's pretty much the same as XP in terms of config and drivers.
My problem is that I can't set optimum pulse width timing parameters in PPjoy. My best behaving timing settings for my Hitec Laser 4 are:
Min servo pulse width: 1375
Max servo pulse width: 1575
Sync pulse width: 4000 (or anything up to about 12000)
The timing widths of the tx are more like 1000 to 2000 and so I only get this tiny window of stick movement. A little movement deflects the servo a lot... It's just too sensitive.
I figured that by opening up the range to... say... 1200 to 1600 in PPjoy, I'd take better advantage of the throw and have a more realistic response. However, setting a timing range wider than 200 causes the virtual servo to "jump" past the end in sort of a wrap-around effect.
How do I get past the problem I'm seeing with the 200 microsecond maximum window in PPJoy?
Thanks,
-Mark