im new to this whole helicopter thing and i would like to get in to it.
I need your help guys.
My helicopter arrived today....RC Dragonfly 2005 4CH Helicopter w/6CH Controller.
I need to know the following please
Why does my tail rotor not spin when my main blades are spinning ?
There is 8 little one buttons behind the remote control,what should these be set at ??????????
i.e what should be left and what should be right ?????????
the 2 silver un and down buttons that can be found up top on the remote control........what are they for ????????
also the little black button next to the top right analog switch ?
Right lads how do i get my copper to fly?
please guide me through the steps in which i need to follow.
The chopper blades spin bar the tail blade.
then when i go to take off the thing just falls over.
please help me out and reply to this guys.
thanks for your time
shane
(ireland)